EQUIPPED WITH:

Gear Lab Machine
150 MB Fanuc
Coolant System
Chip Conveyor
Jib Chain Fall
Manuals

WORKPIECE CAPACITY:
Face Milling Face Hobbing
Extreme Ratio.................. 10:1 10:1
Full Depth (Maximum)........... 1.00" 25.40mm 0.60" 15.24mm
Face Width (Maximum)........... 2.60" 66.00mm 2.00" 50.80mm
Range of Tooth Numbers......... 5 to 200 Inc. 5 to 200 Inc.
Max. Gear Pitch Dia. of Typical 35deg.
Spiral Angle Gear Using Max. Cutter Dia. 12"
Cutter Diameter at the Following Ratios:
Face Milling --------------- Face Hobbing (210mm Dia. Cutter)
1 x 1 - 13.5" - 342.9mm ---- 10.56" - 268.22mm
2 x 1 - 16.0" - 406.4mm ---- 10.83" - 275.00mm
5 x 1 - 16.0" - 406.4mm ---- 10.83" - 275.00mm
MACHINE SPECIFICATIONS:
X-Horizontal Travel............ -4.50" to 7.00" -114mm to 178mm
Y-Vertical Travel.............. -7.00" to 7.50" -178mm to 190mm
Z-Sliding Base Travel.......... -5.20" to 19.70" -131mm to 500mm

AXES SPEEDS:
X-Horizontal................... 0 to 3.15"/Sec. 0 to 80mm/Sec.
Y-Vertical..................... 0 to 3.15"/Sec. 0 to 80mm/Sec.
Z-Sliding Base................. 0 to 3.15"/Sec. 0 to 80mm/Sec.
WORKSPINDLE DIMENSIONS:
Dia. if Taper Hole-Large End... 5 3/64" (#50 Taper)*
Taper Per Foot................. 21/32"
Depth of Taper................. 5.29" 134.37mm
Dia. of Hole Through Spindle... 3.35" 85.22mm
Length x Width................ 172" x 174" 438cm x 443cm
Height........................ 98" 230cm
Weight........................ 22,000 lbs. 10,000 kg.