MACHINE #11766

SPECIFICATIONS


-MANUFACTURER: FENN MANUFACTURING COMPANY

-TYPE: WIRE SHAPING LINE

-SPEED: 0 TO APPROXIMATELY 700 FPM (213 MPM)

-LINE CONSISTS OF THE FOLLOWING;

-PAYOFF
-TYPE: LAZY SUSAN TYPE VERTICAL PAYOFF

-STRAIGHTENER
-TYPE: SINGLE PLANE VERTICAL PLANE TO GUIDE WIRE

-WIRE DRAWING STATION
-DIE BOX: 2 DIE UNIT

-CAPSTAN
-TYPE: SINGLE FLAT CAPSTAN
-DIA: 17 1/2" (444.5mm)

-DRIVE MOTOR: 25 HP (18.6Kw) DC
1750/2300 RPM
500 VOLT 43.4 AMPS

-GEAR BOX: RIGHT ANGLE WORM GEAR

-TURKSHEAD
-MANUFACTURER: FENN
-MODEL: 4U
-TYPE: UNIVERSAL

-ROLLING MILL
-MANUFACTURER: FENN
-TYPE: 2HI WIRE FLATTENING MILL
-MODEL: 083

-ROLLS
-TYPE: ARBOR WITH 2" (50.8mm) WIDE CARBIDE SHELLS

-SIZE
-DIE: 8" (203.2mm)
-FACE WIDTH: 4" (101.6mm)

-COLUMN SIZE: 5" X 5 1/4" (127mm X 133mm)
-WINDOW OPENING: 8 1/2" (215.9mm)

-SCREWDOWN TYPE: MANUAL

-BEARING TYPE: ROLLER

-BEARING LUBE: OIL- PASSIVE

-ENTRY TABLE/GUIDES: ENTRY SIDE ONLY

-DRIVE MOTOR: 40 HP (29.8Kw)
850/1700 RPM

-TURKSHEAD
-MANUFACTURER: FENN
-MODEL 61U PD
-TYPE: UNIVERSAL TYPE POWER DRIVEN

-ROLLS
-DIAMETER: 6" (152.4mm)
-FACE WIDTH: APPROXIMATELY 3/4" (19.05mm)

-DRIVE: TURKSHEAD SETUP IS A TYPICAL DRIVEN UPPER AND
LOWER ROLLS VIA DRIVE SHAFTS FROM A PINION STAND.
PINION STAND IS DRIVEN VIA CHAIN FROM THE MILL
THROUGH AN AIR CONTROLLED WITCHITA CLUTCH.

-TRAVERSING REEL
-MANUFACTURER: FENN
-MODEL: APPEARS TO BE A MODEL 1210

-TYPE: HYDRAULIC TRAVERSING TAKE UP REEL

-CAPACITY: APPROXIMATELY 1,000 LBS (454 k)

-MAXIMUM TENSION: 200 LBS

-MAXIMUM TRAVERSE: 10" (254mm)

-DRIVING FLANGE: 10" (254mm) DIA

-DRIVE: REEL IS DRIVEN OFF THE SAME CHAIN/WITCHITA CLUTCH
ARRANGEMENT THAT DRIVES THE POWER DRIVEN
TURKSHEAD BEFORE IT.

-ACCUMULATING DRUM: 16" (406.4mm) I.D. X 8 3/8" (212.7mm) FACE

-DRIVE FOR LINE
-TYPE: EUROTHERM FOUR QUADRANT DIGITAL
590 SERIES DC DRIVES
GE FANUC SERIES 90-3 PROGRAMMABLE LOGIC

CONTROLLER.

**PRICE QUOTED IS EX-WORKS AS IS WHERE IS SUBJECT TO PRIOR SALE**

**ALL SPECIFICATIONS ARE SUBJECT TO VERIFICATION BY PURCHASER**