Model No. 17A GLEASON Hypoid Bevel Gear Testing
Machine, Serial No. 24726

Note: Suitable for the testing of straight bevel,
spiral bevel, and hypoid gears with shafts
intersecting at 90-degrees, with capacity to test
gears up to 20" (508mm) pitch diameter

EQUIPPED WITH:
Hydraulic work chucking cylinders on pinion
and gear spindles, (less draw-in bar & nuts)
5-HP, 220/440V, 3-ph 60 cyc, 1670 rpm main drive motor
3/4 HP, 220/440V, 3-ph 60 cyc, 1745 rpm
hydraulic motor
Pre-set backlash control
Brake spindle (3-29/32" bore dia. large end)
Adjustable drive pinion spindle (3-29/32" bore dia.
large end) w/crank handle & graduated dial
Load meter
Guards, covers, handwheels
Full complement of electrics, motors/controls)
(w/MODICON 512/612 Micro PLC control)

SPECIFICATIONS:
Maximum offset of gear spindle above
or below center of pinion spindle...... 3.5" (88.9mm)
Maximum distance from center of gear spindle
to nose of pinion spindle.............. 12" (304.8mm)
Minimum distance from center of gear spindle
to nose of pinion spindle.............. 6" (152.4mm)
Maximum distance from center of pinion
spindle to nose of gear spindle........ 7.75" (196.85mm)
Minimum distance from center of pinion spindle
to nose of gear spindle................ 4.13" (104.8mm)
Max diameter of gear with "zero" offset of
gear spindle........................... 20" (508mm)
Machine dimensions (approx.)........... 60"x 73"x 60"
Machine net weight..................... 5,300 Lbs.