WASHING MACHINES, (Also See Degreasers)
Mart, 60" diameter x 48" part ht, 5000# cap, 40 HP, cabinet & sound insulation, rinse sys, recond
1996 Mart Tornado, 60" Diam. Table x 48" Part Ht, 70 HP Power Washer W0504-711
Model Tornado 60 Mfg. in Dec. 1996 Serial 4391
SMTS Reconditioning Procedures:
1. Cabinet, table drive, power blast manifold, all functions inspected, & cleaned, repaired as needed.
2. Defective parts repaired or replaced, cabinet is cleaned as needed, repainted with original factory colors.
3. Power up & Cycled under simulated shop conditions, test all electrical, mechanical, and hydraulic functions.
4. You receive our "Peace of Mind" Parts Warranty." ( SMTS will send replacement for any motor, pump or heat system parts that are found defective within 90 days from shipping date. )
SMTS Reconditioning Procedures insure you will receive the best possible return on your investment.
The resulting reduction in labor, increase in sales volume, cleaner factory floor, improved quality, reduced material expense plus many more results make this investment justification just plain common sense.
Note #1 Extremely dirty parts require a Aqueous Power Washer which utilizes a combination of High pressure, High Temperature, Environmentally Safe Chemicals, and a Power Blast Manifold that is oscillating and non-synchronised.
Many companies around the world have relied on these combinations to get their parts clean, and so can you. Please call for references of Fortune 500 companies that use these systems currently.
Washer Equipped With: (Temporary Information only, please verify upon inspection)
70 HP/203 PSI Duplex Pump System, 50 HP/20HP Pumps ( **** See additional information below )
System Pressure: 203 PSI (measured at the nozzle)
Blast Velocity: 173 feet per second (measured at the nozzle)
System Flow: 371 Gallons Per Minute (GPM) (measured at the nozzle)
System Flow per Nozzle: 18.6 GPM (measured at the nozzle)
**** Mart Duplex Pumps are high efficiency Industrial Grade systems without metal-to-metal contact in the wet end, rated for continuous duty and multiple starts, vertical mounted seal-less design, capable of passing 1/2 inch solids and balanced to within .0074 inch ounces/ounce, with hardened steel Pump Shaft Sleeves, hardened stainless steel Throttle Bushings, and bearings rated for 50,000 hr.. Barrel style Motor-to-Pump mountings and flexible coupling ensure positive alignment and reliability without periodic adjustment.
Thermal / Sound Insulation (Heat loss and noise reduced below 90 dBA)
Reservoir cover (Thermal barrier, prevents small parts falling into reservoir, operator protection)
Push Button Jog (Easy loading of parts and inspecting of finished parts)
Auto Rinse Cycle
Remote Grease fittings
Power Blast Manifold, oscillating and
Source: Steam HeatTemperature: 140-180
(20) Stainless Wash Nozzles
Automatic Cycle Timers with 7 Day Clock
Timers, Wash Cycle and Rinse Cycle with up to 30 minute capacity
Emergency Stop Button
Electric Requirements 60 kW, 460 V / 3P/60 C, 163 Amp Full Load
Specifications: (Temporary Information only, please verify upon inspection)
Table Load Capacity:
Normal Operating Temperature:
140-180 Degrees F
Depth 91" . Width 106" , Height 93"
350 Gallon Reservoir Capacity
Sludge Capacity: 80 Gallons
FOB Cleveland, OK